Timing Cover Removal A Step-by-Step Guide for Automotive Excellence

I removed the four hidden 13MM bolts under the oil pan, and all the 10mm (27) bolts on the case itself, I have spread 3/8" at the correct pry notch. To replace the timing cover on the 3rd Generation is an a time consuming job, but can be done home with the proper tools. First thing to do is unhook the ... Try this removal: Disconnect battery ground cable, then remove accessory drive belts. Remove engine cooling fan, hub and shroud. Remove crankshaft damper hub ... Timing covers replacement steps · Cleaning and Inspection: The engine block and surrounding areas are thoroughly cleaned to remove any ... Honda Civic / Del Sol (1992 - 2000) - Upper timing cover removal w/o pulling valve cover ? - I think I have a cam seal leak I want to check ... make sure you don't drill all the way into the timing chain cover itself!!! Insert a screw or puller in the drilled hole and pull.. Alternatively, you can use a ... Loosen the front 2 pan gasket bolts and with some finagling and a bit of prying at the right spots, you can get those triangles to slip into place with some ... Take two tapered punches that fit in the timing cover bolt holes and use them to pry the timing cover down and push back at the same time to force the cover ... You have to remove the idler pulley anyway (since it shares the bolts with the lower timing cover), so after you remove that you can easily get ... I would replace the timing cover gasket if you're going to have it off just for a preventative measure. My timing cover was weeping a little bit ...