Precision Timing Cover Replacement A Step-by-Step Guide for Experts

I found the 14mm Gear Wrench to make short work of loosening the bolt for removing the TC. This 14mm bolt is removed from the rear side of the Power Steering ... The Upper Oil-Pan should be adjusted/aligned to the rear engine cover, otherwise it might lead to some strange reverb sounds. The only thing I know about is replacing your stock cover with a two or three piece cover. The oil pan gaskets can be a pain to seal as it is. All you have to do is unbolt the front two bolts on the oil pan to release pressure on the timing chain cover enough to slip it out. timing cover removal think i messed up ... Just remove the cover and turn the motor over so the cam timing gear dot is at 6 o'clock and the crank ... You need to remove the Vanos, sprockets, chain and I believe tensioner to get these all out. There is an alignment dowel on intake or exhaust side. No you don't have to take the sump completey off. Lossen the sump bolts until the sump comes away from the block. you need about 3-5mm then the ... Looks like its the ever elusive timing chain cover leak directly below the rear head gasket.. same old question guys.. please chime in ... Once you get all the accessory brackets off and all the bolts out of the timing cover, you have to drop the oil pan bottom plate and remove 3 - 5 bolts from ... 1: Remove coil covers and coils (Might want to remove plugs, not if you are careful) 2: Unbolt cam covers and support somewhere in the center to raise it off ...