DIY Timing Cover Removal A Comprehensive Guide for Enthusiasts

Loosen up some of the otherbolts on the oil pan, to allow some room for the timing cover to move around. If not there may be pressure from the ... make sure you don't drill all the way into the timing chain cover itself!!! Insert a screw or puller in the drilled hole and pull.. Alternatively, you can use a ... Moparts Question and Answer, Unlawfl's Race & Engine Tech, Gen III Hemi Tech, Moparts Restoration & A12 Forum Corners Are Best - Handling Tech. Looks like its the ever elusive timing chain cover leak directly below the rear head gasket.. same old question guys.. please chime in ... You will have to support the front of the engine in order to remove the timing cover. You do not have to pull the oil pan. That front section of ... Removing the timing cover in order to replace the gasket will take quite a bit of time and cost a lot for labor. Replacing the timing ... Start by kicking the bottom out a touch and the bring it out. While its out use a little RTV to glue the valve cover gaskets into the covers. Simply take all the oil pan bolts out, and let the oil pan hang down as much as it would allow, then removed the timing cover and went from there. You can do the front cover pull with the engine in the truck, but it is a tedious PITA! You will have to drain the oil, loosen all the oil pan ... Nope.. just take out the 2 maybe 3 bolts that go into the timing chain cover.. the gasket kit well come to 2 small pieces of cork gaskets to ...