Expert Seat Removal Overcoming Motor Malfunctions

Funny I was just searching to see if there's a better method of removal but I think the only way is to make the seat go as high as possible - ... Found a way to do it without power. If you pull the side plastic cover and look towards the front of the frame you will find a square head fitting. If you pull out the torx bolts, the slider will detach from the motor screw drive and the seat can manually be slid forwards and backwards. This ... There really isn't a way to manually crank them. If you look under the seat, you can see the screw drives that move the seats around. While removing the seat and replacing the bad motor(s) or wiring is the long-term solution, using a winder tool (or power drill) as described in this article ... You do not have to remove the seat to just disconnect the harness and check power at the connectors, but yes I did remove the seats because they ... It is not necessary to remove seat to remove seat motors, it can be done by removing the back seat and lay down where rear seat was and get under seats to ... As Martha Stewart says, "It's a good thing." Always start with the obvious. Get a flashlight and take a slow, methodical look under the seat, ... Motor is dead 3. Switch is dead 4. Seat misaligned on rails. I ... You can remove the seat yourself, just make sure to undo all of the ... Ask the front desk at the yard if you can borrow a battery jump pack. If they allow that, you can get power to the negative and positive cables ...