Unveiling the Nightmare Fumoto Plastic Hose Barb's Surprising Failure

... rubber hose springs a leak all the oil is dumped in the bilge. look at the n series valves the have hose fittings. http://www.fumotousa ... hose here and suck out ... I went parts shopping and got a pump, fittings, hose, but no check valves. I did find some 3/4" NPT, but it was going to take 3 bushings and a barb fitting to ... Got a Mityvac to suck the oil out. Just stick a plastic tube down the oil dip stick tube. Used it once so far, worked better than I expected ... Keep topping it off as the engine sucks it through (after thermostat open) ... Then attach a clear plastic hose to run down to a jug. Fill system ... It's very difficult to wrestle around with fuel in it. ... 2 fittings for 1/2” hose that can be attached to the filler neck. These can be 90 degree brass/metal ... Fumoto for my next one. Ford gave me the minimum service contract as ... Yet another solution is to get a one-quart plastic container (milk, ... The problem with sucking it out the dipstick tube ... The pump is connected to a 1/4" plastic line that you stick down the dipstick tube. I was doing an oil change yesterday and was planning to swap in a Fumoto valve. Drain went great, no splashing, every drop in the pan. on my charger i have a plastic plate that covers the bottom of the motor, so no problems. ... You just had to uncap it and screw on a hose fitting ... Have been using a "Fumoto" drain valve on my Honda Ridgeline for three years now and really like it. I slip a short hose on the nipple and just ...