Fumoto Plastic Hose Barbs The Bane of Your Fluid Transfer System

The problem with sucking it out the dipstick tube ... The pump is connected to a 1/4" plastic line that you stick down the dipstick tube. You then attach a piece of clear vinyl hose to the nipple of the Fumoto, and run the drain hose over and out the side of the engine protection ... The size is 16mm-1.5, and there's a Fumoto valve with hose adapter that fits: ... Plan B: I inserted a 3/16" hard plastic tube (vacuum tube) ... Not sellers fault they even refunded me $30 for the radiator being bent so I agreed can't complain they were very understanding just sucks to have a damaged ... but if you note the 05 up performance brand has plastic ... Also, the drain on these Mishi rads sucks. It ... I added a Fumoto valve to mine with a 3/8" hose barb ... The hardest part was tightening the hoses to the base where the old filter was. Do yourself a favor and make sure you have an open end wrench, ... As for replacement, I'd use bio-compatible bulk 1/2' fuel line. Dorman makes a plastic quick-connect fitting with a hose barb on it, but you can ... ... plastic cover instead of going everywhere. I've seen similar ... Just stick a hose inside and suck out the oil. It's cleaner and gets ... 1) I used a plastic NPT-to-hose-barb adapter from Home Depot. It was ... suck it out of the dipstick tube! Reply 3 · Cafcpete's Avatar. It's very difficult to wrestle around with fuel in it. ... 2 fittings for 1/2” hose that can be attached to the filler neck. These can be 90 degree brass/metal ...