Unveiling the Disaster Fumoto Plastic Hose Barb's Catastrophic Impact

on my charger i have a plastic plate that covers the bottom of the motor, so no problems. ... You just had to uncap it and screw on a hose fitting ... ... suck it up. I. ... barbed hose fittings threaded into those. I had ... With a metal tank, perhaps some sort of plastic level (similar to a Weber float bowl gauge) ... ... plastic snap retainer clip fitting holding the lines together. Is ... Fumoto Oil Drain Valve, Drilled CAC Weep Hole thru Support. Save ... sucks the blood of humans and animals.ewflfrom the verb yflto He ... tube.2 a long, narrow container made of plastic or thin metal. The ... Fumoto's little plastic lever lock was probably knocked off by ... sucking the oil out of the dipstick tube? Bill. 2019 Obsidian Blue ... ... sucking it out through the dipstick hole. Replacing the oil pan drain plug with a valve and hose-barb seemed like the answer. Fumoto of ... I installed a Fumoto valve and now consider it to have been a waste of money. First, it has such a small diameter drain hole and tube that it ... Sounds like you have a mismatch but even properly sized hoses can really suck. Kinda baffles me. I had a sailboat with an inboard and the ... Are you using the small plastic tube going down the dipstick hole? ... On my previous Merc boat, I installed a Fumoto drain valve with a barbed ... With the plastic drain plug, I doubt there is a Fumoto valve available that would fit the 2.7 or 3.5. Not sure about the 5.0. Dec 14, 2017 | 02: ...