Exposing the Nightmare Fumoto Plastic Hose Barb's Horrifying Experience

I went parts shopping and got a pump, fittings, hose, but no check valves. I did find some 3/4" NPT, but it was going to take 3 bushings and a barb fitting to ... harbor freight has the perfect catch container for oil changes, its cheap, its plastic, it hold a lot of oil. ... hose to it. Turn the The 20baja outlaw has a sweat set up, when you pull the drain plug far enough, the hose from the pan is connected to it. Just remove the fitting ... Have one on my Dodge RAM, as factory drain bolt sucked badly. Works fine, no leaks. A bit on a slow side drain. Oh, and you can put drain tube ... I run a VTA can and just replaced the valve with a hose fitting of the correct threads, boom done. I did it just for simplicity, one less ... I used Fumoto on my Tundra back in the day and the flow rate is sloooowww compared to without it. With the 5.8L engine with huge oil capacity, ... and that tube is then used to suck ... making sure the inserted plastic tube is at the bottom. ... Use more 3/8" hose to attach the other barb and to the Mityvac, ... The Ronin plug seems like a neat idea, esp. if you attach a hose to the outlet. I agree. If I hadn't already had the Stahlbus fitting (and ... key to good flow is the rubber grommet and plastic line fitting ... You insert a plastic tube into the dipstick tube and feed it all the ... I finally hooked up my Reverso to my MG-502 transmissions using 5/8”-18 drain valves from Fumoto and 3/8” fuel hose from Amazon.