Say Goodbye to Leaks with the Invincible Fumoto Plastic Hose Barb

1) I used a plastic NPT-to-hose-barb adapter from Home Depot. It was ... suck it out of the dipstick tube! Reply 3 · Cafcpete's Avatar. It was a little tricky to snake the plastic suction tube down the ... It was so easy to measure with dipstick, add a piece of tape to the sucking ... ... Fumoto fittings themselves are pretty stout. Sep 21, 2020 | 12:19 PM ... Sucks that it got stripped! You're right about 18ft lbs not ... There's also a setup that has a fitting and hose installed between the engine block and sending unit. ... The plastic oil extractor suction tube ... The 20baja outlaw has a sweat set up, when you pull the drain plug far enough, the hose from the pan is connected to it. Just remove the fitting ... I'm cornvinced the culprit is the built-on plastic washer of the OEM plug. Never saw a bung like that b4 and never had problems with stuck bung ... ... suck some of the oil from the hose back into the system. No harm ... 40/20/40 seat conversion, Fumoto drain, Pre OEM secondary fuel ... ... rubber hose springs a leak all the oil is dumped in the bilge. look at the n series valves the have hose fittings. http://www.fumotousa ... hose here and suck out ... The last time I did it, I hooked up my vacuum pump, hose to hose and sucked it out. ... Fumoto would work without some combination of fittings ... This should get 99% of the oil out. I found if you stick the tube in, it will only suck oil 'locally' ... I still plan fitting a Stahlbus or ...