Unmasking the Truth Fumoto Plastic Hose Barbs and Their Unreliability

Used the provided plastic straw inserted down the dip stick tube. ... Then one day I noticed the extractor hose fitting on the various ... ... sucked. You naturally need the the fittings that go from the 1/4 copper pipe to the garden hose fitting. On the other side I used a piece of old garden hose. I was doing an oil change yesterday and was planning to swap in a Fumoto valve. Drain went great, no splashing, every drop in the pan. There's also a setup that has a fitting and hose installed between the engine block and sending unit. ... The plastic oil extractor suction tube ... I have a plastic tube connected to it and a plug in the end of the tube. ... It has a hose fitting on the end and I have a short piece of ... The 20baja outlaw has a sweat set up, when you pull the drain plug far enough, the hose from the pan is connected to it. Just remove the fitting ... Have one on my Dodge RAM, as factory drain bolt sucked badly. Works fine, no leaks. A bit on a slow side drain. Oh, and you can put drain tube ... Only drawback was then engine required about 1/2 liter more oil because of the hoses. Biggest concern was always possiblity of blowing a hose, ... ... plastic snap retainer clip fitting holding the lines together. Is ... Fumoto Oil Drain Valve, Drilled CAC Weep Hole thru Support. Save ... Fumoto fittings themselves are pretty stout. Sep 21, 2020 | 12:19 PM ... Sucks that it got stripped! You're right about 18ft lbs not ...