Revitalize Your Vehicle with CV Boot Replacement

If the boot's actually torn, I'd probably replace the axle. If it's just cracked and the CV's are still good, then go with the boot kit, but on both front ... Keep in mind, on mine at least (and yours is probably the same) the inner and outer joints are different. The outer is a spring clip that you ... My advice would be do the whole axle, when you get the point of where you would just do the boot, you are just a pry bar and hammer hit away from removing the ... replacing the inner joint boot requires removal of the axle without a lift, the plunge joint usually has a tripod of 3 roundish rings over ... I recently did the rear end and noticed that the CV boots need to be changed. Autohaus only has the outer boot kit. If your vehicle vibrates during acceleration, then you might need a new inner CV joint. The outer joint can cause vibrations too but outer joint ... maybe a split-boot kit will work for you. You must keep it clean and carefully read the directions. You cut away the old boot and replace it ... If it is just the boot it's actually not a bad deal take it to the local Trans shop they have rebuild kits new Grease and boot. I work for one ... ... have the boot replace. I've searched the forums and i could only find inner cv joint boots replacement DIYs. Just wondering if anyone ... It's not hard to do at all. If you are replacing the outer CV boot I highly recommend disassembling the inner CV and sliding both boots off the shaft toward ...