Don't Neglect CV Boots, Replace Them Promptly

With the driveshaft in situ (also the suspension-strut & draglink desecured and the d'shaft's splined outer end loosened and slid oit of the ... I'd just get a Cardone new axle for $36.79 + tax and shipping with lifetime warranty instead. 2 Beck Arnley boots will run you about $25 + tax and shipping. That way you dont have to mess with any of the suspension or brakes. I was just wondering if someone that has done it a few times could just ... If you have a rubber vibration damper on the axle it has to come off too. Then you slide the outer boot all the way up the axle and off the ... re-pack grease into the joint,put the boot around(cut the ends off,to the diameter you need),then glue the seam/recess,and let it go off.i would ... replacing the inner joint boot requires removal of the axle without a lift, the plunge joint usually has a tripod of 3 roundish rings over ... ... replacement inner and outer clamps that you can try. Have ... If you're going to reboot your CV axles, you should also replace the ... The boot will crack over time. You don't need to replace the axle. If you want to be sure, take it to a shop. Have it cleaned, repacked with grease, and slip a ... you'll need to clean the halfshaft before you put on the new boot, now is a good time. if necessary, rotate the halfshaft to expose the snap ... If you inspect it, you will see that it is just there as a support for the rubber boot. It does not have to be perfect, just round enough so ...