Prevent Transmission Failure with Inner and Outer CV Boot Replacement

With the boot bearings and inner housings exposed you will need to locate C clip that is located in the inner CV Cup (the part that includes the ... Thank you very much. I'm just going to have both the left and right axle assembly replaced since it is about time anyway. I'll save the old ... If you have a leaking cv boot there are these split cv boots you can use to replace them. you can basically wrap the cv boot around and glue it ... If you have a rubber vibration damper on the axle it has to come off too. Then you slide the outer boot all the way up the axle and off the ... Depending on how long the boot has been cracked, "maintenance by degrees" is probably a good plan here if you haven't noticed any noise or ... If the outer boot was cracked or ... @ bailcast.com/products/cvs18-universal-cv-boot, they have fitting instructions that recommend: you'll need to clean the halfshaft before you put on the new boot, now is a good time. if necessary, rotate the halfshaft to expose the snap ... Once you get the CV joint to the bench, clean it out (Preferrably by taking it apart) , regrease it (press lots of grease way inside where ... My advice would be do the whole axle, when you get the point of where you would just do the boot, you are just a pry bar and hammer hit away from removing the ... you can then remove and replace the outer boot by sliding it along the shaft . or remove shaft leaving outer cv joint in hub if you need to ...