Maximize Your Vehicle's Performance Replace Tie Rod Boot with Precision

You definitely don't want to leave the tie rod with the broken boot. It will get contamination in there and fail much faster. At this point, you ... If you need to replace just the boot, because it cracked due to age, and the tie rod joint itself, is still good, I'd look into an Energy ... To replace the inner tie-rod boot, you will need to release outer tie-rod end from knuckle, and remove the outer tie-rod end (release locknut and turn off). Anyone replace just the boots on the tie rods? They look like ... Also, I would like to replace the boots on the outer tie rod ends, as ... Clamps can be popped off easily without the right tool and then just use zip ties. I know the last rods I replaced, the boots were all ... Unfortunately, you'll have to unscrew the tie rod end. Mark where the lock nut is located, crack loose it a tiny bit and then remove the outer ... unless you just happen to have it available... Quite sure the RH boot on mine is original and is as good as new still after 200k km. Both my tie ... The replacement 'kit' is a boot, a puck (so you can slip it over an existing tie rod and just repair the boot) and a couple of clamps. Well... finally got the sucker figured out. The driver's side was a HUGE PITA... I ended up pulling the boot over a bottle in the garage, ... Picture of the threads you need to match. ... 21.5. Now you can put in the outer zip tie on. 22. After getting your new inner/outer tie rods as ...