Essential Guide to Tie Rod Boot Repair Keep Your Car Safe

The day has come that I need to replace a torn tie rod boot ... I've seen many complaining here lately that they can't get just the replacement ... You don't have to take the tie rod end out of the knuckle you can just unthread the tie rod from the tie rod end and since the rack end is a ... Autozone "HELP!" section has some generic boots that may work. Or you could get the tie rod exchanged as Moog has a lifetime warranty on them. Your suggestion to replace just the boots is a good one, but I don't think I have enough finesse as a mechanic to do it, nor do I have the ... Not wanting to spend approximately $600 to replace both tie-rods and extensions, the guy at my local NAPA found replacement boots that fit. Picture of the threads you need to match. ... 21.5. Now you can put in the outer zip tie on. 22. After getting your new inner/outer tie rods as ... My passenger side tie rod boot was ripped not too long ago and I'm wondering if I should replace the boot or the entire rack. Congrats - we all knew you could do it. Enengy Suspesion makes ball joint boots too. However, if your old ones are still in tact, I'd leave them ... That's because they only have two flats on the OEM rod ends and they don't always line up in a way that a wrench will go on them. You're also ... You don't have to separate the tie rod end from the ball joint, unless you want to. I would just twist the inner tie rod until it was out of the ...