Mastering Control The Importance of Pilot Wires in Control Systems

yes, Ant Cont is for the motor of a power antenna, and you have the amp remote correct. both put out 12 vdc. P Con whenever the unit is on, Ant ... #1: There is a BLACK with a RED stripe. #2: there is two PINK with a LIGHT BLUE stripe that were joint together (one was a jumper between 2 ... "Using a 12-volt tester, test the power wires at the existing antenna plug. The wire which shows +12 volts with the radio on and -12 volts with ... That wiring adapter kit also included an "antenna adapter", which itself also has a blue wire. What gets connected to what? All three together? If you manage to pull out the radio you can tap into that because the antenna remote (that feeds the antenna amplifier) is switched with the radio. The jumper harness wiring kit crutchfield sent me for my truck says blue wire is for power antenna. The pioneer wire harness instructions ... the blue wire is sort of like an amp turn on lead, but for the antenna, it gives it a little bit of extra juice. You connect in with a blue or ... The blue wire from the antenna adaptor goes to the blue Pioneer wire that controls the power antenna (which the Cube doesn't have). I pulled everything out and connected the blue antenna wires (radio to wiring harness pin #14) and re-installed everything. The verdict: no improvement in ... One is solid blue and marked "POWER ANTENNA". The other is blue with a white stripe and marked "AMP TURN ON 12v+". Im assuming the one i need is ...