Delving into the Details A Closer Look at Pant Wires

The antenna wire from the head unit needs to connect to the antenna turn on wire on the 10 pin connector. Soon as I connected this, every channel came in as HD. The amp remote wire and the antenna wire are pretty much the same thing,they just sent a signal to the amp/antenna to tell it to turn on.The ... The antenna wire is orange and it runs behind the passenger air bag to the radio. You can barely see it or get to it from the glove compartment. The blue antenna wire the OP is speaking of comes on the back of aftermarket head units which gets used for a remotes turn on lead for amplifiers used for ... Start by confirming you have voltage at the designated wire coming out of the harness when turning on your radio. If so, then do the same at the electrical ... the blue wire is sort of like an amp turn on lead, but for the antenna, it gives it a little bit of extra juice. You connect in with a blue or ... Do we need to connect this blue wire to the power antenna lead of the aftermarket radio in order for this adapter to work properly? I would ... Your new stereo should have a blue wire. It is just a switched +12 V output that is limited to a few hundred mA. This is meant for raising the ... My '99 FSM shows C1 Pin 8 is the power antenna and amplifier relay feed-coil. It is a dark green wire. Left to right: pin 10 is orange, pin 9 is ... Easy and free solution #1. Connect both blue (to power antenna) and blue/white (to remote amp terminal) wires to the blue/white (remote wire ...