Control Redefined The Essential Guide to Pilot Wires

I originally hooked the blue antenna wire coming out of the kenwood to the blue "power antenna" wire on the wiring harness. Bad reception. I ... The remote turn on wire is responsible for turning your amplifier on and off. This blue wire (typically with a white stripe), may be even more important to ... 1 - The antenna has constant ground and power wires. The third wire is a signal wire that triggers the antenna to raise. It lowers when there is ... The antenna wire is orange and it runs behind the passenger air bag to the radio. You can barely see it or get to it from the glove compartment. The Power antenna wire has 12V+ on it only when the Radio Tuner is on. If you have a CD playing or something else, you wont be powering the ... I have Pioneer DEH6300UB head unit, the harness for the pioneer has a "System Remote Control" blue/white wire which in the manual says ... "Using a 12-volt tester, test the power wires at the existing antenna plug. The wire which shows +12 volts with the radio on and -12 volts with ... Ant.cont. is used to control a power antenna. Radio comes on..ant. goes up...radio off...ant down. p.cont. is used to turn on car amp. That wire does put out 12v when the radio is switched on. I wired the "P. Cont" from the HU to the "PWR ANT" wire on the harness and now all is ... b+ is to the positive of your battery remote can be hooked to power antenna ... I still recomend running the wire from the cd player or the ACC ...