Demystifying Ignition Switch Resistance Why It Doesn't Turn Left?

... doesn't interface with the ignition switch coil, distributor, or starter. ... turn signal switch, the left signal came on, and vice-versa. It sounds like the switch does not line up correctly. If you have the original switch, compare them very carefully including how far they turn before making ... Anyone having this problem: remove the shift knob so you see just the lever and button and try to fully turn the car off and take the key out again. If you have ... The ignition switches on these fall apart. Basically, you have to grind off the two safety bolts that hold the ignition switch on and replace ... I turned the key in the ignition and nothing happened. My ... Whatever energy remains in the batter is available right away, and doesn't ... Double check that the ignition switch harness 6-P connector is securely attached to the driver's under-dash fuse/relay box. Issue #1 - After unwrapping 1/2 a roll of electrical tape, I discovered with the PO left behind. I am very tempted to cut them and splice new ... You might have thought a fuse would blow somewhere. Start pulling unrelated fuses and see if and when the power dissapears to the wipers or rear ... Now check the main fuse and wiring to the ignition switch for power. Check that power goes through the ignition switch when it is turned on. I'm pretty sure it doesn't but they can insist. If I read right that you put the fob into the switch and it comes out wet with water, you ...