Ignition Switch Quandary Why Won't It Turn Left?

A bad lock cylinder typically won't turn at all when you put the key in, or it won't pop up when the key is removed. If it turns at all from ... When the switch at the shifter fails, it locks up the ignition. Try bumping the shifter handle to see if that helps, if so, you may have to get ... the common solution is to get : 1 - a temporary key and ignition barrel from the stealership....this is cheaper solution....but you will have an ... First, disconnect the battery. Do it ASAP, like now. Then take your steering column apart, and have a look for fried wires. Sounds like your ignition switch is bad, with both the ACC and START (IGN2) positions failed. However, it could be in the wiring, though the ACC ... In my case the fix was to turn the key to on position and give a good pull on the steering wheel( as to Straightening out wheels)...and she ... On the longer type key there is a coil on the end and the wire on the end can break where it is soldered on, giving an intermittent operation, ... If not, replace the switch. Some switches have multiple positions so you need to make sure you are on the correct pin to the ignition. Another ... The ignition should be no voltage also. Here is a pic of the fuse panel. That ignition lug is supplied power by one of these relays. I just ... Try to spray some lubricant in the keyed lock cylinder and see if that may help frees it up if so, you can then remove it and see if it turns freely outside of ...