Fog Light Switch Failure Troubleshooting and Repairing the Circuit

All wires should be protected by fuses or circuit breaker to prevent wire fromcatching fire whould it short out. that is what fuses are for ... Pull one to see which is for the fog lights. Or just inspect both fuses and note which is for the fogs. The fog lights will be fused together, ... There is no relay included with the kit. My stock IROC foglights shorted out and I couldnt trace the short so I just installed a new pair of ... It appears that the lights themselves as well as the light in the switch are all powered from fuse 3 under the hood so I would check that out ... You might carefully inspect the wiring behind the lights themselves. There have been multiple reports of them rubbing and shorting out. If it is and the fuse is not blown, turn the fog lamp switch ON and check for +12v power at any fog lamps connector terminal "A". If there is no ... If a 15A fuse is blowing, there's a major problem. Best case the short is near or in the connector, which is the highest resistance part of the ... Most likely the multi function switch has gone bad, very common. Pull the fog light relay to kill the fogs and go find a new switch. Someone ... The first case would be caused by insufficient voltage on the control pins (coil pins of the relay). You'll need to figure out a way to measure ... If the fuse pops when the switch is activated then its a short at either the wire to the left or right fog, or the wiring to the fog light ...