Troubleshooting Fog Light Shorts A Step-by-Step Guide

I had a light burn out on my truck, and I thought it was going to be a simple light change. I was wrong. Since these lights are low down on ... I looked to see if maybe there was a fuse out, but I couldn't find a fog light specific fuse in the fusebox under the hood. I tried to see if ... The left and right fog lamps are on separate circuits powered and controlled by the BCM. It is possible that your connector issue caused the BCM ... If it's soldered in place, then, without removing the relay, remove the fuse to verify the fog lights go out. This will indicate if the short ... The fog lights should stay on -- in fact when making a sharp turn the sidespread of the fog lights might even help to illuminate the turn. The Right foglight doesn't work! and when i scanned the car with ForScan it says. Code: B1148 - Right Front Fog Lamps Additional Fault ... If a 15A fuse is blowing, there's a major problem. Best case the short is near or in the connector, which is the highest resistance part of the ... He could not work out why the light remained on. Assessed all the fuses related to the fog light. Removed the fog lamp. He decided to short the ... Condensation could cause a short circuit and cause a fuse to blow but thats pretty rare. The fuse would blow (even a higher amp one) before the ... Did you electrically verify, with an ohm meter or continuity tester, that the bulb is burned out, or open? :confused: Bobby... ['07 FSXT MODding ...