Fog Light Corrosion Detecting and Preventing Electrical Malfunctions

When it was time to make the connection, I wanted to make sure which wire was power and ground, so we don't cause a short to the new bulb. He ... The left and right fog lamps are on separate circuits powered and controlled by the BCM. It is possible that your connector issue caused the BCM ... 2) Check dash and make sure the high beam indicator is not illuminated. 3) get out check from front of car to verify the low beam headlights are ... On the other hand, you mentioned that the driver side is shorted to ground. If wiring were fine, that should cause the passenger side to show ... Pull one to see which is for the fog lights. Or just inspect both fuses and note which is for the fogs. The fog lights will be fused together, ... If it's soldered in place, then, without removing the relay, remove the fuse to verify the fog lights go out. This will indicate if the short ... He could not work out why the light remained on. Assessed all the fuses related to the fog light. Removed the fog lamp. He decided to short the ... You might carefully inspect the wiring behind the lights themselves. There have been multiple reports of them rubbing and shorting out. 281.8K1w ago. krugerconstruction. Kruger Construction. Check out these @Diode Dynamics SS3 Max Fog lights ... Alright, I'll make this video short ... The same fuse in the ER box that powers the "fog light on" indicator is the same for the fog lights. Thus, if you had a short, it would clear ...