Top Brake Light Illuminated? Unraveling the Causes and Cures

It sounds like the brake light switch at the top of the pedal is either sticking or needs to be adjusted. Make sure you check all your fuses and wires. Normally its not the wires or fuses, but you always want to be sure. If you buy the car from ... If all 3 lights are staying on, I would inspect the sensor to be sure it's not out of position. If only the 3rd brake light is staying on, and ... The third (center) brake light on my 2011 Buick Lucerne stays on constantly, even when the car is not running. I do not know if the bulbs can be replaced. Most forums suggested that if the brake lights came on, but didn't illuminate brighter when the brake pedal was pushed, it was a brake switch or ... the brake lights stay on without me pushing the brake, idk what to do? need help asap! ... :yup: your switch that the brake pedal presses\ ... On your brake pedal there is a little plastic grommet that contacts the switch to activate the brake lights when you press on the pedal. It has ... The brake light is activated in two possible ways: 1. A pressure-activated switch attached to your front brake light, usually mounted on the lower triple-tree ... Brake light switch is at the top of the brake pedal behind the kick panel trim under the drivers side of the dash. I went back and checked front and back brake again. Turned out the back brake was getting very slightly stuck, just enough to keep the light on.