Expert Tips to Fix Your Persistent Top Brake Light

The brake peddle is differant, I would need to disconnect a wire and check it with an Ohm meter. Since you just worked on the lights that makes ... The cause of this, they said, was that the LED bulbs had an improper resistance level in comparison to the stock incandescent 3157 bulb. In addition to brake lights that are stuck on, another symptom of a stuck brake switch is that the engine will start and the transmission can be ... Also check the brake fluid level see if it is too low. I remember too low brake fluid level will also turn the warning light on. Top ... You may have replaced one of the tail light bulbs with the wrong one. It may be shorting two circuits together. So the brake light stays on. If it doesn't work, then I believe the brake light switch you've already checked is at fault. ... And to clarify, my cruise would still work but ... Normal brake lights activate when brake pedal is depressed. I also have a rear windshield wiper that runs constantly, and I unplugged it. I've " ... The third brake light is on all the time, even after the XC is turned off. I have the check stop lamp message in the display. Any suggestions. If not and still on, try also disconnecting the stop lamp relay in the underhood fuse relay box, located left rear of engine compartment. If it's still lit, ... The next thing they need to check is the harness to the rear lighting. My guess is that another wire is shorting against the 3rd brake giving it ...