Tackle the Stubborn Top Brake Light Troubleshooting and Repair

Probably a problem with the new wiring and possible relay(s) if they added some. It is possible that they have added a second brake light switch ... Are the tail light bulbs dual filament with the brake lights using same bulb, are you sure both bulbs are in sockets properly and not bridging ... Also check the switch pad, it's a dime sized rubber spot that clicks into a hole in the pedal arm tab. The hole the pad mounts to is just ... ... you buy a aftermarket 3rd brake light and when you plug it in it stays lite up ... My Content and want to be a Patreon here is the link http://www ... Also check the brake fluid level see if it is too low. I remember too low brake fluid level will also turn the warning light on. Top ... On your brake pedal there is a little plastic grommet that contacts the switch to activate the brake lights when you press on the pedal. It has ... It could be that the brake pedal stop has broken. If that piece breaks, the car assumes the brakes are stuck on and it leaves the brake lights ... My 3rd brake light was on, not full bright, but maybe 25-50% of its power. When I apply brake, it came 100% with 2 side brake light and when I release brake ... Damaged brake light switch or sensor · Faulty or stuck brake pedal · Broken stopper · Damaged electricals · Wrong bulbs · Corrosion/ rusting. Here are the things I've noticed while researching this issue. Brake light on tail lights work as intended. You press the brake and they light ...