Top Brake Light Persistence A Comprehensive Guide to Troubleshooting

Easy one of your brake light bulb solder has melted and is touching tail light and feedback pull your brake bulbs and look at the contacts. ;). Also check the switch pad, it's a dime sized rubber spot that clicks into a hole in the pedal arm tab. The hole the pad mounts to is just ... Sounds like it might be a bad brake light switch. I would take a look at that. I would bet that if you disconnect it the lights will go out. The cause of this, they said, was that the LED bulbs had an improper resistance level in comparison to the stock incandescent 3157 bulb. The main brake lights are always on when my headlights are on. Not the third brake light on the cab, just the two tail light portions. Two possible causes to start with: 1. A short in one of the brake light bulbs between the tail light & brake light filaments. With the parking ... If you were talking about the parking brake light, you probably just need to top up the brake fluid... the brake light switch is on the firewall under the hood at the rear valve cover.. It is ''Hot'' all the time, key on or off.. or on the treadle ... You may have replaced one of the tail light bulbs with the wrong one. It may be shorting two circuits together. So the brake light stays on. It could be that the brake pedal stop has broken. If that piece breaks, the car assumes the brakes are stuck on and it leaves the brake lights ...