Top Brake Light on the Fritz? Diagnose and Repair Like a Pro

Probably a problem with the new wiring and possible relay(s) if they added some. It is possible that they have added a second brake light switch ... Bad switch or the tip of the switch needs to be adjusted. Push on the brake pedal and adjust the switch by pushing in. on w212 the switch is ... probably something with the brake light switch on the brake pedal. try pulling up on the brake pedal and if the lights go off, then you can ... If you were talking about the parking brake light, you probably just need to top up the brake fluid... the brake lights stay on without me pushing the brake, idk what to do? need help asap! ... :yup: your switch that the brake pedal presses\ ... I went back and checked front and back brake again. Turned out the back brake was getting very slightly stuck, just enough to keep the light on. If it's all of the brake lights, I'd lean towards the brake light switch, but just to eliminate the recon tails as the problem, I'd try ... If this is happening with the vehicle off and sitting, this can potentially kill the battery as well. I would recommend checkin the brake light ... The third brake light is on all the time, even after the XC is turned off. I have the check stop lamp message in the display. Any suggestions. My actual symptom was the the brake lights was constantly on (all 3 lights, both tail and the center light) and it caused a battery drain to ...