Transform Your Fluid Transfer with the Unbeatable Fumoto Plastic Hose Barb

I have an 8” piece of old fuel hose I connect to the fumoto when ... I have the short version which comes with a plastic barbed fitting that snaps ... I was doing an oil change yesterday and was planning to swap in a Fumoto valve. Drain went great, no splashing, every drop in the pan. I used Hydraulic hose fittings ( hose too ) because they are shorter ... Takes 15min to suck five gal from pigtail hose permanently attached to ... The plastic retention clip on my Fumoto valve was missing. It was 100% installed last OC. Fortunately the valve itself remained closed. Swapped out filter and finish sucking out the rest by moving the hose around. Is it as fast as a Fumoto, doubt it. But I didnt have to jack ... The plastic belly pan doesn't have a huge hole around the engine oil drain plug, so getting a fumoto with a hose barb probably isn't a bad idea. ... suck it up. I. ... barbed hose fittings threaded into those. I had ... With a metal tank, perhaps some sort of plastic level (similar to a Weber float bowl gauge) ... ... FUMOTO VALVE, RARE PARTS TIE RODS WITH COGNITO PISK, MAD JACK FUEL ... The aftermarket plastic hose barb quick connect fittings (dorman) ... It was a little tricky to snake the plastic suction tube down the ... It was so easy to measure with dipstick, add a piece of tape to the sucking ... ... Fumoto fittings themselves are pretty stout. Sep 21, 2020 | 12:19 PM ... Sucks that it got stripped! You're right about 18ft lbs not ...