Maximize Fluid Efficiency with the Unparalleled Fumoto Plastic Hose Barb

Even the optional elbow fitting looks to drop too low. My solution replaced the OEM drain plug w/ a banjo bolt, w/ the hose fittings coming out ... I'm trying to decide whether to order the straight or 90 degree hose barb for a drain valve. It's a 2.5i. Cheers, -Hirsch "Live your life so that when you ... I used Fumoto on my Tundra back in the day and the flow rate is sloooowww compared to without it. With the 5.8L engine with huge oil capacity, ... ... sucking it out through the dipstick hole. Replacing the oil pan drain plug with a valve and hose-barb seemed like the answer. Fumoto of ... I used Hydraulic hose fittings ( hose too ) because they are shorter ... Takes 15min to suck five gal from pigtail hose permanently attached to ... I'm using distilled water + 10%-15% coolant, no problems. ... hose barb built in. ndog · Mentor · ndog · Posted ... Stopcock and plastic hose would probably do the ... finger around ends of hoses at fitting for seepage. <--- Please fill ... I found a tiny crack in the plastic of the radiator near the drain plug ... I have an 8” piece of old fuel hose I connect to the fumoto when ... I have the short version which comes with a plastic barbed fitting that snaps ... The hardest part was tightening the hoses to the base where the old filter was. Do yourself a favor and make sure you have an open end wrench, ... It would suck to break that fitting off and lose your oil !! Reply 0 ... I have the Fumoto valve (the one with the lever). 7/8" w ...