Embrace Leak-Free Fluid Handling with the Innovative Fumoto Plastic Hose Barb

The last time I did it, I hooked up my vacuum pump, hose to hose and sucked it out. ... Fumoto would work without some combination of fittings ... The hardest part was tightening the hoses to the base where the old filter was. Do yourself a favor and make sure you have an open end wrench, ... ... tube' using the supplied rubber compression fittings. It seems to me that one would be able to do a more complete oil change by sucking oil ... As for replacement, I'd use bio-compatible bulk 1/2' fuel line. Dorman makes a plastic quick-connect fitting with a hose barb on it, but you can ... The extractor works by sliding a thin line down the dipstick tube (and into the pan) and then pumping the vacuum in order to suck the oil out. With the plastic drain plug, I doubt there is a Fumoto valve available that would fit the 2.7 or 3.5. Not sure about the 5.0. Dec 14, 2017 | 02: ... I was doing an oil change yesterday and was planning to swap in a Fumoto valve. Drain went great, no splashing, every drop in the pan. This should get 99% of the oil out. I found if you stick the tube in, it will only suck oil 'locally' ... I still plan fitting a Stahlbus or ... but if you note the 05 up performance brand has plastic ... Also, the drain on these Mishi rads sucks. It ... I added a Fumoto valve to mine with a 3/8" hose barb ... Sounds like you have a mismatch but even properly sized hoses can really suck. Kinda baffles me. I had a sailboat with an inboard and the ...