Transform Your Ride The Power of Indexing Steering U-Joints

When I built my Willys I used a steering shaft from a 5 ton truck cut down, look at the big truck wrecking yards. The U joints are baby Spicer ( ... Has anyone had any luck replacing just the lower U-Joint to avoid having to take all the bits off the column around the steering wheel? looks ... With your whole getup out of the car, your best bet is to use a cold chisel and wedge the pinching fingers apart to R&R the u-joint. I don't ... Find ppictures, count splines. They changed based on specific year, even within the generation, and changed based on whether the rack was ... you might try snap-on for a tool like that. i copied someone else's tool and made my own. It would be standard process to just change the U ... Well I'm about half way finished. For starters the U-joint is almost 3/4 inch longer than the rag joint. I slid the U-joint onto the spines so ... Clocking CV's is pointless. Clocking U-joints is not. Method is the same as a driveshaft as long as your first and last shaft are parallel. If they are ... If you're looking for a project for your vehicle, take a look at the steering couplers and shafts in your steering system. Re: Steering U-joint issue? first, check each steering shaft from the top to the bottom to make sure all the u joints are in phase with each ... I put the yoke in a vise and simply drove the u-joint all the way to one side, and grind away the inside of the yoke (i used a die grinder ...