Reimagine Mobility Discover the Power of Universal Joint Replacement

New video tutorial detailing the replacement of U-Joints on a 240 with a 2" drive shaft. There are no "U-joints" on Subaru drivetrain. U-joints always come in pairs to counteract the rotational acceleration/deceleration inherent in the design. The replacement joints will have snap-rings on the inside of the joints to hold them in place. I will attempt to press mine out, and then see if ... Has anyone successfully replaced the u-joint on their two piece driveshaft? Those things appear to be non-serviceable. 1. Dissemble the plastic cover on the steering wheel console like you were going to grease the u joint. If you are this far just a little more and you'll be at ... in the process of replacing old and worn parts we decided to replace the U-joints as well, now heres the question. ive been trying to remove ... That indicates worn bores or (less likely) mis sized U-joint caps. If caps slide in by hand, you should think about replacing that driveshaft ... The U-joints should simply bolt on so I don't think a replacement like this would be too labor intensive or confusing, let us know how it goes, and good luck! It should feel snug, but not tight or stiff. When replacing u joints I usually will do a short, forceful tap on each cap without the clips in to ... The U-joint is staked in and appears to have a cap diameter of 26mm or 1.024”x 80mm or 3.088” (ish). Anyone have actual dimensions? Or has anyone replaced one?