Precision Technology Meets Pain Relief Universal Joint Replacement

An upgrade path would be to replace the driveshafts with heavier duty units that utilize u-joints, particularly a one piece driveshaft in the rear. Never done my frontier yet, but their regular 1310 series joints that can be had anywhere for 15 bucks, time to change varies with experience, a ... You have to heat and heat to get all that **** out of there. If its properly done it will not bend the shaft. I have had to set it up in the ... I decided to tackle it myself and take a few photos in the process. I used only hand tools that I had to show how to replace these without any fancy tools so ... The U-joints should simply bolt on so I don't think a replacement like this would be too labor intensive or confusing, let us know how it goes, and good luck! You have to heat the yoke and melt the plastic/nylon out. Then change the joint as normal. When you install the joint you will need to use the supplied clips. New video tutorial detailing the replacement of U-Joints on a 240 with a 2" drive shaft. It should feel snug, but not tight or stiff. When replacing u joints I usually will do a short, forceful tap on each cap without the clips in to ... the joint is replaced as a whole unit on the shaft by mercedes. You can however take it in to a local driveline shop and they will cut the ... The u-joints on the cars are considered non-replaceable. if you look closely they are prick punched in and not held in with snap rings. i have ...