Brake Pedal to the Floor Empower Yourself with Troubleshooting Tips

A bad power brake booster could make the brake pedal go to the floor only when the engine is running, which is the primary issue that I am experiencing. I started the engine, tightened the hose clamp all the way down til there was no vacuum and loosened it til the pedal felt right. it takes about ... Welcome to the SS Forums @Castros408 !! Brakes that go to the floor, on the first stroke, with no resistance will have me looking at everything ... If the braking system works by compressing fluid and there isn't enough fluid in the system, you will experience a spongy pedal or worst case a ... Pedal goes to the floor then has like an inch of actual brakes. Don't see any line leaks, bled them, replaced a wheel cylinder made sure the drums were tight. Try replacing the brake fluid, check pads and discs etc. Sounds like old, spongy fluid to me. Brake system has air in it, brake master cylinder or wheel calipers are defective, brake lines are leaking- most often, these issues are ... It sounds like you have an internal leak in your brake master cylinder. With steady pressure the brake pedal should not move, if it does then it ... This could indicate an unevenly worn rotor, dirty brake fluid or contamination of the fluid by moisture. You can solve such a problem with a relatively ... Most likely the Master Cylinder piston seals are leaking internally which is why the fluid level stays the same. You could either rebuild the ...