Brake Pedal to the Floor? Uncover the Underlying Causes and Solutions

It's either a burned out bulb, or it fell victim to something in the creative wiring done by the previous owner (discovered more of that ... Old decrepit hydraulic brake flex hoses, they get mushy and can cause the foot brake to the floor issue, there are two up front and two in the ... The truck wouldn't stop unless you put your foot to the floor. After bleeding all the wheels again, same problem. I found out there is a "fifth" bleeder ... The pedal should not "go to the floor" at any time. There should come a point in the pedal travel where it no longer moves down. It's not actually on the floor; you still have some breaking if only one of the two circuits fails. I'd first look for a leaking line, usually ... Pedal goes to the floor then has like an inch of actual brakes. Don't see any line leaks, bled them, replaced a wheel cylinder made sure the drums were tight. The only way fluid levels decreases is by worn brakes (taking more fluid to push worn pads further to make contact puts the fluid in the caliper ... in that case it looks like the fluid return cup on your master cylinder piston is swollen,closing off the orifice, preventing fluid from ... When seals in the master cylinder go bad, one day (hopefully not on a downhill offramp) you will press the brake pedal and it just goes down. It ... The theory of a dual master cylinder is you'll still have front or rear brakes if the opposite end of the car/truck fails. Usually by the time ...