Brake Pedal Goes to the Floor Your Step-by-Step Troubleshooting Guide

Most likely the Master Cylinder piston seals are leaking internally which is why the fluid level stays the same. You could either rebuild the ... Check to see if the pads aren't binding in the caliper bracket, and check that the caliper bolts are allowing the caliper to move as it should. 1. Place a clean shop cloth beneath the brake master cylinder to prevent brake fluid spills. 2. With the ignition OFF and the brakes cool, apply ... It sounds like you have an internal leak in your brake master cylinder. With steady pressure the brake pedal should not move, if it does then it ... The brake pedal goes to the floor with very little resistance. It isn't spongy like there is air in the lines. It just goes to the floor if you push it all the ... First of all, it is a pretty good bet the master cylinder has been damaged by pushing the brake pedal to the floor. Crud and corrosion build up ... It turns out that it was caused by one of the rear wheel cylinders leaking brake fluid past the piston cup seal. The internal cups weren't ... Sounds like multiple problems going on the way you describe it. Replacing the pads (if that's all he did/ rotors too) really shouldn't have ... Some things I would check: 1. Is the fluid level dropping in the reservoir? Check for leaks throughout entire system. 2. Look at the fluid in the reservoir and ... This could indicate an unevenly worn rotor, dirty brake fluid or contamination of the fluid by moisture. You can solve such a problem with a relatively ...