Say Goodbye to CV Boot Problems Inner and Outer Replacement Guide

Depending on how long the boot has been cracked, "maintenance by degrees" is probably a good plan here if you haven't noticed any noise or ... I did a search for my '87 at a Toyota parts dealer and found that they are different. Dealer search here. The outer boot is discontinued. You have to remove the axle (have fun breaking the 32mm nut) then you'll need a vice to hold onto the axle while you tap the end off of it. Then ... you'll need to clean the halfshaft before you put on the new boot, now is a good time. if necessary, rotate the halfshaft to expose the snap ... Keep in mind, on mine at least (and yours is probably the same) the inner and outer joints are different. The outer is a spring clip that you ... If you hear any noise while driving or turning then you should replace the entire axle. On step 7 there is some extra instructions on what to do if replacing ... To do what you described you'd need to get the boot over the outer CV. Most boots have a limit of about 3.5", which is not big enough to go over ... Let me tell you how it is done in a shop, and how you should do it: Place vehicle on hoist 6" above ground. Remove all four CV boot clamps. Pull ... It's not cost effective to clean, regrease, and replace boots, so you can drive it till it starts clunking, then install a rebuit half shaft. If ... I bought one CV boot kit (inner and outer and grease) from T. Rutland's and used the boots to do both inners. So, yes. Inner and outer boots are ...