Empower Yourself Comprehensive Inner and Outer CV Boot Replacement Guide

The driveaxle has inner and outer constant velocity (CV) joints which are greased and covered by rubber boots. CV boots on these cars have a history of early ... ... have the boot replace. I've searched the forums and i could only find inner cv joint boots replacement DIYs. Just wondering if anyone ... To do what you described you'd need to get the boot over the outer CV. Most boots have a limit of about 3.5", which is not big enough to go over ... Jack car and take tyre off, release steak nut locking device (half shaft retaining nut) with screw driver/chisel and pound hammer taking care ... To properly remove and replace the inner cv axle boot, you must remove the axle shaft from the car. Many people choose to replace the axle ... Depending on how long the boot has been cracked, "maintenance by degrees" is probably a good plan here if you haven't noticed any noise or ... Hey all...My passenger inner CV boot took a dump and needs to be replaced. I've had two mechanics say they won't replace just the boot, ... I need to replace the inner CV joint boot (gaiter) due to damage. Item no. 2 i figure below. I assume the drive shaft will have to removed from the vehicle. you'll need to clean the halfshaft before you put on the new boot, now is a good time. if necessary, rotate the halfshaft to expose the snap ... If you have 8 lugs, you need the 8600 pieces. Last I checked, inner and outer boots are the same for the 8600 trucks. And it was the precision ...