Embrace Driveline Excellence CV Boot Replacement for Inner and Outer Mastery

And I don't recall having to keep straight "inner boot" vs "outer boot" when we went to replace them, ie I think they're identical. If you were ... You can replace both boots but you have to disassemble your inner CV to remove the old ones and replace. If your outer boot is torn, just ... To do what you described you'd need to get the boot over the outer CV. Most boots have a limit of about 3.5", which is not big enough to go over ... Jack car and take tyre off, release steak nut locking device (half shaft retaining nut) with screw driver/chisel and pound hammer taking care ... Usually to replace a CV boot you need to remove the driveshaft and then disassemble the CV joint to put the new boot on. Depending on how long the boot has been cracked, "maintenance by degrees" is probably a good plan here if you haven't noticed any noise or ... re-pack grease into the joint,put the boot around(cut the ends off,to the diameter you need),then glue the seam/recess,and let it go off.i would ... I did a search for my '87 at a Toyota parts dealer and found that they are different. Dealer search here. The outer boot is discontinued. I bought one CV boot kit (inner and outer and grease) from T. Rutland's and used the boots to do both inners. So, yes. Inner and outer boots are ... If you have a rubber vibration damper on the axle it has to come off too. Then you slide the outer boot all the way up the axle and off the ...