Timing Cover Removal The Ultimate Troubleshooting Guide

Its not to hard, take the tensioner out, take the gear off and zip tie the chain to the gear. Do the work you need to do with the front off and ... I would replace the timing cover gasket if you're going to have it off just for a preventative measure. My timing cover was weeping a little bit ... I am to the point of getting the timing chain off and finally removing the rocker arms and cylinder head itself. However, nothing I do can ... General Tech Help - Remove Timing Belt Cover - Hi all, from reading other threads I think my front counter shaft seal is going bad so I want ... I found the 14mm Gear Wrench to make short work of loosening the bolt for removing the TC. This 14mm bolt is removed from the rear side of the Power Steering ... Loosen up some of the otherbolts on the oil pan, to allow some room for the timing cover to move around. If not there may be pressure from the ... The procedures to replace timing chain in FSM call for removing/lifting the engine with a hoist, plus power steering pump. The job is fairly easy, in fact it's taken me now...6 hours to tear it all down and get the cover back bolted on to the block! To replace the timing cover on the 3rd Generation is an a time consuming job, but can be done home with the proper tools. First thing to do is unhook the ... To remove the timing cover there are 10 10mm bolts. 9 of them are on the outside edge of the cover while one of them is in the middle, circled in green in the ...