Command Your Ignition The Ultimate Guide to Starter Power Control

A solenoid would be ON the starter (the smaller cylinder). There is no difference between the 2 large terminals. Would try charging the battery a bit or jumper starting and see if anything changes, then try checking the battery cable to the starter and the ... The starter solenoid is bad on my 966. It started several weeks ago clicking but not starting. It feels like the Ben fix is pulling in but the starter motor ... The power to the solenoid has to pass through the fusible link, the ignition switch, the clutch start switch, and the theft deterrent relay to get to the ... Sounds like a bad starter motor maybe. Getting high resistance when hot. I would check all the connections going to the starter for corrosion ... Purple will only have 12v when the key is held in crank posistion is the negative battery cable attached to passenger head. The purple wire going to the solenoid should get power when you turn the key to the start position. Did you check for that? If the TIPM see's a start request and a P/N signal it will apply power to pin 85 of the starter relay. pin 86 will be grounded by either the ... It only works if i jump it at the solenoid. everything else ignition related works fine. and i get power in the large red/black wire from the ignition in the ... 2011 Murano that will not try to crank when the starter button is pushed. All lights and gauges work. Battery has been load tested and new starter.