Unlock Engine Potential Resetting Throttle Position Sensors for Enhanced Performance

Unhooked battery to reset tables. Still faults. Noticed the brake sensor switch at brake master cylinder always showing yes condition, probably ... Hold the pedal all the way down for 20 to 30 seconds. Depress the Start/Stop button as if turning off the engine. Remove the foot from the gas ... To zero the TPS: 1. Set the Run/Stop switch to the Run position. 2. Turn the ignition key to the On position. 3. With the engine off, rotate the throttle grip. Add a comment... 9:11 · Go to channel · Signs & Symptoms of a Bad Throttle Position Sensor (TPS)!. 8020 Media•434K views•9 months ago · 8:06. Perform “Throttle Valve Closed Position Learning”. 3. Start engine and warm it up to normal operating temperature. 4. Turn ignition switch “OFF” ... Then turn your key to the 'on' position (do NOT start the car) and wait at least 10 seconds. Release the accelerator, then take the key out ... Here's one for you; In the past few weeks, I've now had to do the throttle position sensor reset procedure three or four times. Symptom; start ... The following procedure must be performed: a. Disconnect negative battery cable from battery. Leave cable disconnected for approximately 90 seconds. To do the tps-turn the key to the run position (not started), slowly depress the throttle pedal all the way to the floor, slowly release to idle. Turn the key to the on position but DON'T start the engine. Now press the gas peddle to the floor SLOWLY and let it come up/back as fast as you can, turn key ...