Reset Your Throttle Position Sensor Reclaim Your Engine's Lost Power

Turn on the IGNITION SWITCH, wait for the CEL (Yellow engine light) to turn OFF.... ... Turn off IGN only... wait for 10 seconds and repeat this ... ... sensor surfaces or the throttle body. Use a brush or a clean cloth to do so. 4. Look for the throttle position sensor that is found on the ... I have the Service Bulletin and used it to install the new TPS but at the end of the instructions it says you need to Reset the TPS memory ... Please make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ... Set up your Flash Tool. Click on Diagnostics, then click on My Bike, then Throttle Position. The Flash Tool will prompt you to turn on the key at the proper ... To do the tps-turn the key to the run position (not started), slowly depress the throttle pedal all the way to the floor, slowly release to idle. To reset the TPS I turn the key to on, kill switch on, rotate the throttle fully three times and return it to rest. Turn the key off. The TPS is now reset. The global position, as returned by the Global Positioning System (GPS). This is. NOT the global position estimate of the system, but rather a RAW sensor value. The mechanic will turn the car off and disconnect the negative battery terminal. They'll wait 5 to 10 minutes. This allows the engine control unit (ECU) to ... Completely replacing your sensor may be the best way to avoid future issues, but some issues can be easily fixed by reprogramming or repairing your sensor.