Throttle Position Sensor Reset The Key to Smooth Engine Operation and Reduced Emissions

To zero the TPS: 1. Set the Run/Stop switch to the Run position. 2. Turn the ignition key to the On position. 3. With the engine off, rotate the throttle grip. After replacing your throttle body, you should reset it (relearn the idle speed) and possibly reprogram it. This is because modern vehicles require the engine ... Then turn your key to the 'on' position (do NOT start the car) and wait at least 10 seconds. Release the accelerator, then take the key out ... Disconnect the Neg battery terminal, turn on the lights and drain it out. Pretty much does the same thing IIRC. You don't reprogram a throttle position sensor. You reprogram the thing that is reading the TPS. A TPS is just a resistive position sensor ... throttlebody #throttlesensor #tps Is your car feeling sluggish, unresponsive, or just not running as smoothly as it should? ... sensor surfaces or the throttle body. Use a brush or a clean cloth to do so. 4. Look for the throttle position sensor that is found on the ... Step 3: Depress the accelerator REALLY slowly...Driving Miss Daisy with a touch of Cocoon slowly...all the way to the floor. Step 4: Release the ... I have the Service Bulletin and used it to install the new TPS but at the end of the instructions it says you need to Reset the TPS memory ... Push this button while holding down the RESET switch on the Controller. Hold down RESET until “NVRAM CLEAR” appears in green letters on-screen ...