Throttle Position Sensor Reset Empowering Your Engine for Optimal Efficiency

In this video we discuss how to reset the throttle position sensor in a Toyota. We also discuss signs of failure and how the throttle ... To do the tps-turn the key to the run position (not started), slowly depress the throttle pedal all the way to the floor, slowly release to idle. throttlebody #throttlesensor #tps Is your car feeling sluggish, unresponsive, or just not running as smoothly as it should? :confused: MOGolf said: Key on with engine off. Push go pedal to the floor for at least 5 seconds. Release pedal. Turn key off. ... Do I get any kind of light or ... My PCV reads the TPS in it's actual sensor voltage... not sure how PCIII reads it. ~2009 Roadstar Warrior Midnight~ - VBak Intake - AIS Block ... The Throttle Position Sensor, or TPS for short, measures how much the gas pedal is pressed and sends that info to the engine's computer. This ... Hold the kill button down. hold it starter button for 3 seconds. or so and then with no gas. and hold it wide open like this. 3 seconds all set. How do I reset the FI/ECU/TPS interplay so I get back to the baseline? I had thought that simply pulling battery would do it: that changes the ... 1) Turn the key to the on position, the position just before the starter turns over. 2) Press the gas pedal firmly to the floor with the key in the "on" ... Turn ignition switch “OFF” and wait at least 10 seconds. 5. Conform that accelerator pedal is fully released, turn ignition switch “ON” and wait 3 seconds. 6.