Resetting Throttle Position Sensors A Step-by-Step Guide for Enhanced Engine Function

To do the tps-turn the key to the run position (not started), slowly depress the throttle pedal all the way to the floor, slowly release to idle. I found this info on how to do a manual TPS reset: Key on, switch on, engine off. Slow 5 count rotate throttle from closed to wide open. Hold throttle wide ... The global position, as returned by the Global Positioning System (GPS). This is. NOT the global position estimate of the system, but rather a RAW sensor value. My PCV reads the TPS in it's actual sensor voltage... not sure how PCIII reads it. ~2009 Roadstar Warrior Midnight~ - VBak Intake - AIS Block ... AS5600 12-Bit Magnetic Position Sensor · AS7341 Spectral Color Sensor · ATM90E26 ... Factory Reset Switch · GPIO Switch · Haier Climate Switches · H-bridge ... Completely replacing your sensor may be the best way to avoid future issues, but some issues can be easily fixed by reprogramming or repairing your sensor. Turn on the IGNITION SWITCH, wait for the CEL (Yellow engine light) to turn OFF.... ... Turn off IGN only... wait for 10 seconds and repeat this ... Please make sure the accelerator pedal is fully released. Next, turn the ignition on and then turn it off and wait for ten seconds. During these ... The final step before you can ride your new TSP Tuned map is to make sure you reset the powervalve and set the TPS to 0.40v. To reset the TPS I turn the key to on, kill switch on, rotate the throttle fully three times and return it to rest. Turn the key off. The TPS is now reset.