Conquer Stripped Lug Nuts Discover the Ultimate Guide to Painless Extraction

If you have stripped the hex faces, you can try a smaller socket and get it on with a hammer. So if your car has 19mm lug nuts and the nuts ... It's pretty much like a female ez-out. It bites onto the od of the lugnut and takes it off. Then you have to grind some flats on the lugnut base ... Last resort, drill the stud out. It'll get the nut off, but then you'll have to replace the stud too. If you try the screw remover (the cone ... They make sockets specifically for rounded lug nuts, they have spiral groves on the inside, and are supposed to grip the nut enough so you can ... We just put vice grips on the back of the studs (TWO of them!) that were spinning in the hub. Used an air ratchet and the lug nuts backed right ... Go to auto parts store. Buy lug nut removal tool that fits your nut. They are used to remove security keyed nuts when you don't have the keyed ... Find a socket slightly smaller than what's on the car. Hammer the smaller socket on to the lug nut then use a breaker bar to take it off. Also, you can get a die grinder with high speed carbide bit and cut the nut apart. Then you can split it and remove it. I had to do this before ... Take a smallish flat blade screwdriver and a hammer. Punch the screwdriver through the end of the nut with the hammer. Keep working away with the screwdriver. Remove wheel (or other spacer) and check to see if nut is loose. If not, use large punch and hammer on back of hub to push stud back forward ...