Unveiling the Mystery of Backup Light Colors A Comprehensive Guide

Using a Haynes manual for 2009 and earlier the color is white with light green stripe. For 2010 thru 2013 the color also is white with a light green stripe. The power source wire is red with black tracer to the back up switch (same color for the auto trans) from the back light switch it changes color too red with ... If you need to find the right reverse lead wire to trigger your rear view backup camera install, This tutorial is for you. The wire should be orange, at least it is on my 23 JLUR.. but depending on the size of lights you plan to run in the rear proper way to do this is to wire in a ... Compare the wires to both taillights. There should be different colors for the stop/turn lights. All the others wires to the taillights/backup ... ... light itself, and you can then chose to view it's location in the chassis and the pin-assignment/wire colors at that connector. Easy-peasy ... I found out it is the blue wire(12V +). I put the car in reverse with hand brake on then unplugged the tail light wires harness, used an amp meter. Your reverse lights are on the bottom of the car near the bottom of the bumper, so just look under the bumper and you should see the wires going up thru a hole ... Looking to install two led reverse lights into reverse lights under truck what colors is the wires coming off reverse lights , hot? ground? The purpose of the purple wire is to activate the rear view camera when the car is in reverse. The pics I posted show you what it looked like ...