The Ultimate Backup Light Color Guide Enhance Your Safety

I did not need any wire from the truck for the backup camera. The camera has three wires - black and red go to the reverse light wire and ground ... Your reverse lights are on the bottom of the car near the bottom of the bumper, so just look under the bumper and you should see the wires going up thru a hole ... You can find the reverse wire under the center console. The plug on the rh side dark green wire pin number 16. i was hoping not to do it again. Save Ground is black. Switched positive (12 V) is BrY, which I believe is Brown with yellow stripe. Can't see how a mis-wiring could blow the back-up ... It's a 16 gauge grey wire that runs from the switch to the underhood fuse block. Pin B11 on connector C2. Goes to two fuses: VEH B/U 15A fuse, and TRL B/U 10A The wire should be orange, at least it is on my 23 JLUR.. but depending on the size of lights you plan to run in the rear proper way to do this is to wire in a ... I looked, and it shows a black connector. Pin #1 is power and should be Orange. The ground should be Red and be pin 2. should be white/Lt green @ the Integrated poweer module. Should be the same color @ the light itself, i'd just go there. My backup camera wired up as soup described. I picked up power for the camera from light green wire attached to the backup lamp.